TSX L4-2.4L (2005)
7. Apply multipurpose grease to the sliding surfaces of the regulator (A) where shown.
8. Install the glass and regulator in the reverse order of removal, and note these items:
-
Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
-
Check for water leaks.
-
Test-drive and check for wind noise and rattles.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Make sure the power door locks, windows and power mirror operate properly.
-
Driver's: Perform the power window control unit reset procedure.