TSX L4-2.4L (2005)
Hood Latch Release Cable: Service and Repair
Hood Opener Cable Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the body and related parts.
1. Remove these items:
-
Front fender trim
-
Front grille cover
-
Front Inner fender
-
Kick panel
2. Disconnect the hood opener cable (A) from the hood latch (B).
3. Using a clip remover, detach the clips (C, D), and remove the grommet (E) from the body, then remove the hood opener cable from the vehicle.
Take care not to kink the cable.
4. Install the cable in the reverse order of removal, and note these items:
-
Check for damaged or stress-whitened clips, and replace them with new ones.
-
Route the cable through the holes (F) in the body and front fender bulkhead correctly.
