TSX L4-2.4L (2005)
6. Remove the left kick panel (A) or the right kick panel (B).
1. Pull out the door opening trim (C) as needed from the kick panel hooks (D) and the door opening flange.
2. Left side: Pull the hood release handle, and hold it.
3. Pull the kick panel back by hand to detach the clips (E, F, G), then remove it.
7. Pull out the door opening trim (A) from the trim hooks (B) and around the door opening flange, then remove the trim.
8. Install the trim in the reverse order of removal, and note these items:
-
Check for damaged or stress-whitened clips, and replace them with new ones.
-
Push the clips and hooks into place securely.
-
Make sure the trunk lid opener/fuel fill door opener cable is connected securely.
Rear Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Detach the hook (A) and tab (B) from the B-pillar lower trim (C), and pull the rear door sill trim (D) up by hand to detach the clips (E, F), then
remove it.
2. If necessary, pull the rear side outer trim (G) up to detach the clips (H), then remove the trim.
