TSX L4-2.4L (2005)
9. To remove a front drain valve (A) from the body, remove the kick panel, left or right. Tie a string to the top end of the drain tube, then pull the
front drain tube (B) down out of the A-pillar leaving the string inside the pillar.
10. To remove a rear drain valve (A) from the body, remove these parts:
-
Spare tire lid
-
Trunk rear trim panel
Tie a string to the top end of the rear drain tube (B), then pull back the trunk side trim panel and pull the drain tube down out of the pillar leaving
the string inside the pillar.
11. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
When installing, tie the string to the top end of the new drain tube and pull it up into the roof.
-
Check the frame seal
-
Clean the surface of the frame.
-
When installing the frame, first attach the rear hooks into the body holes.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
12. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
