TSX L4-2.4L (2005)
-
Use only original Acura replacement seat-back covers.
-
Make sure the recline motor harness, side airbag harness, seat-back heater harness (8-way power seat), and OPDS/ODS unit harness
(passenger's seat) are routed properly.
Seat Cushion Cover
1. Remove the front seat.
2. Except manual seat: From under the seat cushion, disconnect the recline motor connector, and the seat-back heater connector on the 8-way power
seat. Detach the side airbag connector clip, OPDS/ ODS unit connector clip on the 4-way power seat, and harness clips. Release the seat cushion
cover from the seat cushion frame spring, then pull the cover back, and remove the clamps.
3. Remove these items from the front seat, manual seat, 4-way power seat, 8-way power seat:
-
Recline cover
-
Center cover
-
Front cover (except manual)
4. Remove the seat-back, 4-way power seat, 8-way power seat.
5. Release the hook strips (A) from both sides the seat cushion.
NOTE: 8-way power seat is shown; 4-way power seat is symmetrical; manual seat is similar, but its seat-back remains on.