TSX L4-2.4L (2005)
Brake Caliper: Service and Repair
Removal and Installation
Front Brake Pad Inspection and Replacement
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Replacement
1. Raise the front of the vehicle, and support it with safety stands in the proper locations. Remove the front wheels.
2. Remove the brake hose mounting bolts (A).
3. Remove the flange bolt (B) while holding the subpin (C) with a wrench being careful not to damage the pin boot, and pivot the caliper (D) up out
of the way. Check the hose and pin boots for damage and deterioration.
4. Remove the pad shims (A) and pads (B).
5. Remove the pad retainers (A).
6. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
7. Check the brake disc for damage and cracks.
8. Clean and install the pad retainers.
