TSX L4-2.4L (2005)
7. Replace the wheel sensor. For correct wheel sensor installation and sealing, make sure to install the flat washer (included in the wheel sensor kit)
onto the sensor bolt. Torque the sensor bolt and the sensor wire harness bolt to 9.8 N.m (7.2 lb-ft).
8. Install a new hub bearing unit with a new 0-ring. Torque the hub bearing unit bolts to 64 N.m (47 lb-ft).
9. Reinstall the brake disc. Torque the brake disc flat screws to 9.8 N.m (7.2 lb-ft).
10. Reinstall the brake caliper. Torque the caliper bracket mounting bolts to 74 N.m (54 lb-ft).
11. Reinstall the brake hose mounting bracket, and torque the bolt to 22 N.m (16 lb-ft).
12. Reinstall the rear wheel. Torque the wheel nuts to 108 N.m (80 lb-ft).
13. If needed, repeat steps 2 thru 12 on the other side.
