TSX L4-2.4L (2005)
15. If you can feel a ridge of metal or hard carbon around the top of each cylinder, remove it with a ridge reamer (A). Follow the reamer
manufacturer's instructions. If the ridge is not removed, it may damage the pistons as they are pushed out.
16. Use the wooden handle of a hammer (A) to drive out the pistons (B).
17. To avoid mix up on reassembly, mark each piston/connecting rod assembly with its cylinder number.
NOTE: The existing number on the connecting rod does not indicate its position in the engine, it indicates the rod bore size.
18. Reinstall the connecting rod bearings and caps after removing each piston/connecting rod assembly.
19. Reinstall the lower block and bearings on the engine in the proper order.
