TSX L4-2.4L (2005)
compartment, then route the hose through and out of the rear engine mount base.
13. Remove the power steering pressure switch from the original feed hose, then install it on the new feed hose with a new 0-ring. Torque the switch to
12 N.m (8.8 lb-ft).
14. Install the new power steering feed hose in the reverse order of removal.
NOTE:
Before you install the feed hose, cover the rack end with tape. This helps to prevent dirt or debris from entering the hose during installation.
^
Torque the gearbox flare nut on the new feed hose to 42 N.m (31 lb-ft).
^
Torque the power steering pump feed hose bolts toll N.m (8.1 lb-if).
^
Torque the feed hose/line holder mounting bolts and the power steering heat shield bolt to 9.8 N.m (7.2 lb-ft).
^
Torque the feed hose bracket bolt to 12 N.m (8.8 lb-ft).
15. Refill the power steering reservoir to the upper level line with Acura Precision Crafted Power Steering Fluid.
16. Start the engine, run it at a fast idle, and turn the steering wheel lock-to-lock several times. This will bleed any air from the power steering system.
17. Recheck the fluid level, and add more if needed. Do not fill the reservoir above the upper level line.
NOTE:
^
Make sure you remove all shop towels used during the procedure.
^
Wipe off any spilled power steering fluid.
18. Center-punch a completion mark above the seventh character of the engine compartment VIN.
Disclaimer
