TSX L4-2.4L (2005)
6. Raise the stake (A), and remove the spindle nut (B).
7. Remove the 6 mm brake disc retaining screws (A).
8. Screw two 8 x 1.25 mm bolts (B) into the disc to push it away from the hub. Turn each bolt two turns at a time to prevent cocking the disc
excessively.
9. Remove the brake disc (C) from the knuckle.
10. Remove the cotter pin (A) from the tie-rod end ball joint, and loosen the nut (B).
NOTE: During installation, install the new cotter pin after tightening the nut, and bend its end as shown.
11. Disconnect the tie-rod end ball joint from the knuckle using the special tool.