TSX L4-2.4L (2005)
Information Bus: Diagnostic Trouble Code Tests and Associated Procedures
B-CAN System Diagnosis Test Mode A
Troubleshooting - B-CAN System Diagnosis Test Mode A
NOTE:
-
Perform this diagnosis first if the symptom is related to the B-CAN system.
-
Always cycle the ignition switch within 3 seconds when prompted in the DTC troubleshooting procedures.
1. Make sure the system is related to B-CAN.
-
Gauge control module
-
Exterior lights
-
Turn signals
-
Entry light control
-
Interior lights
-
Safety indicators
-
Rear window defogger
-
Horns (security and panic)
-
Chimes (key, seatbelt and lights ON)
-
Power windows
-
Moonroof timer
-
Wiper/washer
-
Security
-
Keyless entry
-
Power door locks
-
Climate control
-
Key interlock
-
Dash light brightness
Is the symptom related to the B-CAN system?
YES - Go to step 2.
NO - Go to the system troubleshooting for the system with the symptom.
2. Connect the Honda Diagnostic System (HDS).
3. From BODY ELECTRICAL MENU, select connected units UNIT INFORMATION, and then select CONNECTED UNIT.
-
MICU
-
Door multiplex control unit
-
Gauge control module
-
Combination switch control unit
-
Relay control module
-
Climate control unit
NOTE:
-
If the unit is communicating with the scan tool, DETECT will be displayed.
-
If the unit is not communicating, "NOT AVAILABLE" will be displayed.
Are all control units communicating with the HDS?
YES - Go to step 4.
NO - If all units are not communicating, or only the MICU is communicating, go to DTC B1000 troubleshooting.
4. Select the system that has the problem from the BODY ELECTRICAL MENU, then select DTCs.
Are any DTCs indicated?
YES - Go to step 5.
NO - If the problem is related to one the following items, go to B-CAN System Diagnosis Test Mode C.
-
Exterior lights
-
Turn signals
