TSX L4-2.4L (2005)
Throttle Body: Service and Repair
Removal/ Installation
Throttle Body Removal/Installation
CAUTION: Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II).
If you do, you will seriously injure your finger if the throttle valve is activated.
NOTE: If you are replacing the throttle body, begin from step 1. If you are removing the throttle body, skip step 1 to 3, and begin from step 4.
1. Connect the HDS while the engine is stopped.
2. Select the INSPECTION MENU with the HDS.
3. Do the TP LEARNING CHECK in the ETCS TEST.
4. Disconnect the IAT sensor connector (A).
5. Remove the intake air duct (B).
6. Disconnect the throttle body connector (C).
7. Disconnect the water bypass hoses (D), and plug the water bypass hoses.
8. Disconnect the vacuum hose (E).
9. Remove the harness clip (F) and the throttle body (G).
10. Install the parts in the reverse order of removal with a new gasket (H), then check these items;
-
Do the ECM/PCM idle learn procedure after the throttle body has been replaced.
-
Refill the radiator with engine coolant, and bleed air from the cooling system with the heater valve open.
