TSX L4-2.4L (2005)
Engine Control Module: Testing and Inspection
Control Module Programming and Relearning
How to Remove the ECM/PCM for Testing
If DTC troubleshooting requires voltage or resistance checks at the ECM/PCM connectors, remove the ECM/ PCM and test it:
1. Jump the SCS line with the HDS.
2. Remove the center lower covers (A).
3. Remove the duct (B).
4. Disconnect ECM/PCM connectors (C).
5. Remove the bolts (D), then remove the ECM/PCM (E).
6. Install the ECM/PCM in the reverse order of removal.
7. Open the SCS line with the HDS.
