acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Customer Interest for Oxygen Sensor:|08-012|Page 2843 > < Manifold Pressure/Vacuum Sensor|Locations|Page 2837
Page 1
background image

Oxygen Sensor: Customer Interest
Engine Controls - MIL ON/DTC's P1172 or P2A00 Set

08-012

March 21, 2008

Applies To: 
2004-06 TSX - ALL

2004-06 TSX: MIL Is On With DTC P1172 or P2A00

SYMPTOM

The MIL is on with DIG P1172 (air fuel sensor [sensor 1] circuit out of range, high), DIG P2A00 (air fuel sensor [sensor 1] circuit range/performance
problem), or both.

PROBABLE CAUSE

The air/fuel sensor is damaged by moisture in the exhaust system during engine warm-up.

CORRECTIVE ACTION

Update the PGM-FI software with the HDS, and replace the air/fuel sensor.

NOTE
The PGM-FI software has been changed to delay the operation of the A/F sensor heater when there is a high probability of moisture in the exhaust
system.

PARTS INFORMATION

Air/Fuel Sensor: P/N 36531-RBB-003

SOFTWARE INFORMATION

HDS Software Version: 2.013.011 Feb 2008 (gray)
or later.

Control Module (CM) Update:

Application Version V6.11.04 or later. 

Database Update 06-FEB-2008 or later.

NOTE

If you use an earlier HDS software version, the HDS may incorrectly indicate that the vehicle does not need an update.

The updated PGM-FI software program IDs and P/Ns are shown below. If this, or a later program ID, is the Current Program ID displayed during the
update, the software for this service bulletin is already installed.

WARRANTY CLAIM INFORMATION

Customer Interest for Oxygen Sensor:|08-012|Page 2843 > < Manifold Pressure/Vacuum Sensor|Locations|Page 2837