TSX L4-2.4L (2005)
Repairs and Inspections Required After a Collision: Service and Repair
Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index See: Powertrain
Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble Code Descriptions for the less obvious deployed parts (seat
belt tensioners, front impact sensors, side impact sensors, etc.).
After a collision where the seat belt tensioners deployed, replace these items:
-
SRS unit
-
Seat belt tensioners
-
Front impact sensors
After a collision where the front airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed airbag(s)
-
Seat belt tensioners
-
Front impact sensors
After a collision where the side airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side airbag(s)
-
Side impact sensor(s) (first) for the side(s) that deployed
After a collision where the side curtain airbag(s) deployed, replace these items:
-
SRS unit
-
Deployed side curtain airbag(s)
-
Side impact sensor(s) (first) for the side(s) that deployed
-
Side impact sensor(s) (second) for the side(s) that deployed
-
Roof trim
-
A-pillar trim
-
B-pillar trim
-
C-pillar trim
-
Front grab handle
-
Sunvisor
-
Any related trim clips
After a moderate to severe side or rear collision, inspect for damage on the side curtain airbag or other related components. According to the degree of
damage, replace the components as needed.