TSX L4-2.4L (2005)
21. Position the pump driveshaft (A) in the pump housing, then press it in with the appropriate size socket wrench (B) as shown. Do not apply more
than 1,370 N (140 kgf, 308 lbs.) of pressure.
22. Install the 40 mm snap ring (C) with its radiused edge facing out.
23. Coat the new 23.8 mm O-ring (A) with power steering fluid, then position it on the bottom (B) of the pump housing.
24. Coat the new cover seals (A) and (B) with power steering fluid, then position them into the grooves on the cover (C).
