TSX L4-2.4L (2005)
68. Bend the lock washer back against the flat spots on the rack end joint housing.
69. Apply multi-purpose grease around the rack e joint housing.
70. Apply a light coat of silicone grease to the boo grooves on the rack ends.
71. Clean off any grease or contamination from the boot installation grooves around the gearbox housing. Install the boots on the rack ends with tie-rod
clips, and fit the boot end in the installation grooves in the housing properly.
72. After installing the boots, wipe the grease off the threaded part of the rack end.
73. Install new boot bands by aligning the tabs with the holes of the band.
