TSX L4-2.4L (2005)
^
Place the seal on the slider with the grooved side facing away from the slider.
^
Coat the steering rack piston with power steering fluid.
^
Slide the inner end seal and slider onto the steering rack guide, making sure the grooved part of the seal faces the piston.
^
Separate the cylinder end seal from the slider, and remove the slider from the rack guide.
^
Slide the new backup ring onto the steering guide, and place it and the inner cylinder end seal against the piston.
56. Clean and remove any burrs on the gearbox housing and the cylinder end created by drilling out the stake.
57. Press the steering rack into the gearbox housing:
