TSX L4-2.4L (2005)
^
Place the seal on the slider with the grooved side facing away from the slider.
^
Slide the end seal and slider onto the steering guide. Make sure you do not damage the seal as you push the seal past the gearbox housing
threads.
^
Once the seal is close to the gearbox housing opening, separate the seal from the slider, remove the slider from the rack guide, and push in the
seal with your fingers.
60. Re-install the cylinder end:
^
Secure the gearbox housing with a C-clamp and wooden blocks. Do not clamp the cylinder portion of the housing.
^
Coat the threads of the gearbox cylinder end with power steering fluid, then screw on the cylinder end and torque it to 69 N.m (51 lb-ft). Make
