TSX L4-2.4L (2005)
74. Close the ear part of the band using pincers.
75. Slide the rack right and left to make sure the boots are not twisted or deformed.
76. Center the steering rack within its stroke.
77. Before installing the steering gearbox, make sure that there is no power steering fluid on the mating surface of the gearbox or the front suspension
subframe. To prevent the gearbox mounting bolts from loosening after installation, remove any power steering fluid from the mount cushions and
bolt holes.
78. Wash both sides of the mount cushion mating surfaces with a mild soap and water solution.
79. To install the steering rack, pass the cylinder of the steering gearbox through the wheelwell opening on the driver's side.
80. Carefully move the steering gearbox toward the passenger's side until the pinion shaft clears the wheelwell opening on the body.
81. Rotate the steering gearbox so the pinion shaft points upward.
82. Continue moving the gearbox toward the passenger's side until the steering gearbox is in position. Make sure the power steering return and inlet
lines are routed above the gearbox.
83. Install the pinion shaft grommet, then remove the vinyl tape from the pinion shaft and the brake lines. Align the slot in the pinion shaft grommet
with the lug portion on the valve housing.
