TSX L4-2.4L (2005)
62. Install the valve body:
^
Coat the new 0-ring with grease, and carefully place it on the valve housing.
^
Apply grease to the needle bearing in the gearbox housing, then install the valve body unit by engaging the gears.
^
Torque the flange bolts to 20 N.m (2.0 kg-m, 14 lb-ft).
63. Clean the cylinder line joints. Make sure there is no foreign material in them. Install the cylinder lines in the position you marked in step 47 by
tightening the flare nuts by hand first, then torque them to the specified torque.
64. Apply grease to the sliding surface and circumference of the steering rack guide, and install it into the gearbox housing. Wipe off any grease from
the threaded section of the housing.
65. Install the spring, the rack guide screw, and the locknut.
66. Adjust the rack guide screw.