TSX L4-2.4L (2005)
20. Align the socket holder (A) on the shift cable (B) with the slot in the bracket base (C), then slide the holder into base. Install the shift cable end (D)
over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Push the holder until it snaps
securely in place. Do not install the shift cable by holding the shift cable guide (H).
21. Verify that the shift cable end (A) is properly installed on the mounting stud (B).
22. If improperly installed, remove the shift cable from the bracket base, and reinstall the shift cable. Do not install the shift cable end on the mounting
stud while the shift cable is on the bracket base.
23. Install and tighten the nut.
24. Remove the 6.0 mm (0.24 inch) pin that was installed to hold the shift lever.
25. Move the shift lever to each position, and verify that the A/T gear position indicator follows the transmission range switch.
26. Allow the front wheels to rotate freely.
27. Start the engine, and check the shift lever operation in all gears.
