TSX L4-2.4L (2005)
end of the reservoir hose and clutch pipe to prevent brake fluid from coming out.
11. Remove the O-ring (E) and clutch master cylinder seal (F) from the clutch master cylinder.
12. Install the clutch master cylinder in the reverse order of removal, and note these items:
-
Apply brake assembly lube to the clutch pipe, and install a new O-ring.
-
Tighten the master cylinder mounting nuts to 13 Nm (1.3 kgf-m, 9.4 ft. lbs.).
-
Install the battery base.
-
Install the air cleaner housing.
-
Install the battery. Connect the battery cables; positive (+) cable first, then the negative (-) cable.
-
Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station and XM radio channel presets.
-
Do the power window control unit reset procedure.
13. Make sure the hose clamps (A) are positioned on the master cylinder (B) and reservoir (C) as shown.
14. To prevent the retaining clip (A) from coming off, pry apart the tip of the retaining clip (B) with a screwdriver.
15. Bleed the clutch hydraulic system.
NOTE: Reservoir filling is covered in the bleeding procedure.
