TSX L4-2.4L (2005)
Axle Shaft Assembly: Service and Repair
Driveshaft Disassembly
Driveshaft Disassembly
Special Tools Required
-
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
-
Sliding hammer set, commercially available
-
Boot band pincers, Kent-Moore J-35910 or equivalent, commercially available
Inboard Joint Side:
1. Remove the set ring from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot and dynamic damper.
-
If the boot band is a welded type (A), cut the boot band (B).
-
If the boot band is a double loop type (C), lift up the band bend (D), and push it into the clip (E).
