TSX L4-2.4L (2005)
6. Pack the inboard joint with the joint grease included in the new driveshaft set.
7. Fit the inboard joint onto the driveshaft, and note these items:
-
Reinstall the inboard joint onto the driveshaft by aligning the marks (A) on the inboard joint and the rollers.
-
Hold the driveshaft so the inboard joint is pointing up to prevent it from falling off.
8. Adjust the inboard joint so the rollers are in the middle of the joint, then check the driveshaft length measurement to the figure as shown.
