TSX L4-2.4L (2005)
14. Lift up the boot band tool to bend the free end of the band 90 degrees to the clip. Center-punch the clip, then fold over the remaining tail onto the
clip.
15. Unwind the boot band tool, and cut off the excess free end of the band to leave a 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
16. Bend the band end (A) by tapping it down with a hammer.
NOTE:
-
Make sure the band and clip do not interfere with anything on the vehicle and the band does not move.
-
Remove any grease remaining on the surrounding surfaces.
17. Repeat steps 9 through 16 for the band on the other end of the boot, then go to step 18.
