TSX L4-2.4L (2005)
13. Attach the rubber dam (A), clips (B), and fasteners (C) with adhesive tape to the inside face of the rear window (D) as shown:
-
First attach the rubber dam, then attach the molding (E) around the edge of the rear window. Be sure both end of the molding contact with
bottom of the rubber dam. If necessary, cut the rubber dam.
-
Be sure the clips, and fasteners line up with the alignment marks (F).
-
Be careful not to touch the windshield where adhesive will be applied.
14. Attach the fasteners (A) with adhesive tape to the rear window opening flange (B) of the body on both sides.
