ZDX V6-3.7L (2010)
Front Door Exterior Handle: Service and Repair
Front Door Outer Handle Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the door.
-
Use a clip remover to disconnect the outer handle rod.
1. Raise the glass fully.
2. Remove these items:
-
Door panel See: Front Door Panel/Service and Repair/Front Door Panel Removal/Installation
-
Inner handle See: Front Door Panel/Service and Repair/Front Door Panel Removal/Installation
3. Remove the plastic cover (A) as needed.
1. Disconnect the power door lock actuator connector (B).
2. Remove the rear plug cap (C).
3. Pass the wire harness (D) and the cables (E) through the slits (F) in the plastic cover.
NOTE: If the plastic cover is damaged or torn, replace it with a new one.
4. Driver's door: Pull both side flanges (A) of the retainer (B) outward, and pull out the middle flange area (C) of the outer casing cover (D), then
disconnect the lock cylinder cable (E) from the latch.