ZDX V6-3.7L (2010)
Power Seat Control Module: Testing and Inspection
Ventilated Seat Control Unit Input Test/Replacement
NOTE: Before testing, check the No. 2-4 (AS F/B OPTION) (40 A) fuse in the under-hood fuse box, the No. 16 (7.5 A) fuse in the driver's under-dash
fuse/relay box, and the No. 19 (20 A) fuse in the passenger's under-dash fuse/relay box.
1. Remove the center console trim See: Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Center Console
Removal/Installation.
2. Disconnect the 37P connector (A) from the seat ventilation control unit (B).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Reconnect the 37P connector to the control unit, and do the following input tests.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 5.