ZDX V6-3.7L (2010)
Power Seat Motor: Service and Repair
Front Seat Recline Motor Replacement
Front Seat Recline Motor Replacement
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
NOTE:
-
Put on gloves to protect your hands.
-
The driver's seat is shown; the passenger's seat is similar.
1. Remove the front seat See: Service and Repair/Front Seat Removal/Installation.
2. Remove these items:
-
Seat-back cover/pad See: Seat Cover/Service and Repair/Front Seat-Back Cover Replacement
-
Front seat recline cover See: Service and Repair/Front Seat Recline Cover Removal/Installation
3. Disconnect and detach the recline motor connector (A), and detach the harness clip (B).
4. Release the push nut (A) from the motor side end of the connecting rod (B), gently tap on the motor side of the connecting rod to remove it from
the recline motor (C) and both recline adjusters (D).
5. Remove the rod cover (E).
6. Remove the mounting bolt, then remove the recline motor (A).