ZDX V6-3.7L (2010)
Seat Cover: Service and Repair
Front Seat Cushion Cover Replacement
Front Seat Cushion Cover Replacement
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service and Repair before doing repairs
or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to tear or damage the seat covers.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
The driver's seat is shown; the passenger's seat is similar.
1. Remove the front seat See: Service and Repair/Front Seat Removal/Installation.
2. Remove the front seat recline cover See: Service and Repair/Front Seat Recline Cover Removal/Installation.
3. From under the seat cushion, release the hooks (A) on the elastic straps from the seat cushion frame springs (B), then pull out the back panel
undercover (C).
4. From under the seat cushion (A), disconnect the seat cushion heater connector (B). Detach the harness clip (C) and release the harness holder (D)
from the seat cushion frame springs (E).
