ZDX V6-3.7L (2010)
Brake Fluid Pressure Sensor/Switch: Service and Repair
Brake Fluid Pressure Sensor Removal/Installation
NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
NOTE:
-
Be careful not to damage or bend the brake lines during removal and installation.
-
After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.
1. Drain the brake fluid.
2. Disconnect the 3P connector (BLU) (A) from the left front brake fluid pressure sensor (B).
3. Disconnect the 3P connector (GRY) (C) from the right front brake fluid pressure sensor (D).
4. Remove the brake lines (E) from the 4-way joint (F).
5. Remove the brake 4-way joint.
6. Remove the brake fluid pressure sensor bracket (A).