ZDX V6-3.7L (2010)
Brake Hose/Line: Service and Repair
Brake Hose Replacement
NOTICE
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water.
NOTE:
-
Before reassembling, check that all parts are free of dirt and other foreign particles.
-
Replace parts with new ones whenever specified to do so.
-
After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.
Front
1. Raise and support the vehicle See: Maintenance/Vehicle Lifting/Service and Repair.
2. Remove the front wheel.
3. Disconnect the brake line (A) from the brake hose (B), then remove the brake hose clip (C).
4. Remove the banjo bolt (A), and disconnect the brake hose (B) from the caliper.
5. Remove the brake hose mounting bolt (C), then remove the brake hose.
6. Install the brake hose (A) with the mounting bolt (B).