ZDX V6-3.7L (2010)
Vacuum Brake Booster: Testing and Inspection
Brake Booster Test
Functional Test
1. With the ignition switch in LOCK (0), or press the engine start/stop button to select the OFF mode, press the brake pedal several times to deplete
the vacuum reservoir, then press the brake pedal hard and hold it for 15 seconds. If the brake pedal sinks, either the master cylinder is bypassing
internally or the brake system is leaking. Inspect the brake hoses and lines See: Hydraulic System/Brake Hose/Line/Testing and Inspection.
2. Start the engine with the brake pedal pressed. If the brake pedal sinks slightly, the vacuum booster is operating normally. If the brake pedal height
does not vary, do the brake system test See: Testing and Inspection/Component Tests and General Diagnostics.
Leak Test
1. Press the brake pedal with the engine running, then turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF
mode. The brake pedal height should not vary while pressed for 30 seconds.
-
If the pedal height rises, go to step 6.
-
If it does not rise, go to step 2.
2. Start the engine, and let it idle for 30 seconds. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode,
and wait 30 seconds. Press the brake pedal several times using normal pressure. When the pedal is first pressed, it should be low. On consecutive
applications, the pedal height should gradually rise.
-
If it rises, the booster is OK.
-
If it does not rise, go to step 3.
3. Disconnect the brake booster vacuum hose (A) at the booster. The check valve (B) is built into the hose.
NOTE: If the check valve is faulty, replace the brake booster vacuum hose/check valve as an assembly.
4. Start the engine, and let it idle. There should be vacuum available.
-
If no vacuum is available, the check valve is not working properly. Replace the brake booster vacuum hose and check valve, and retest.
-
If vacuum is found, go to step 5.
5. With the ignition switch in LOCK (0), or press the engine start/stop button to select the OFF mode, reconnect the vacuum hose to the brake
booster.
6. Start the engine, and then pinch the brake booster vacuum hose between the check valve and the booster.
7. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode, and wait 30 seconds. Press the brake pedal
several times using normal pressure. When the pedal is first pressed, it should be low. On consecutive applications, the pedal height should
gradually rise.
-
If the pedal position does not vary, inspect the O-ring between the master cylinder and booster. If the O-ring is OK, replace the brake booster.
-
If the pedal position varies, replace the brake booster vacuum hose/check valve as an assembly.