ZDX V6-3.7L (2010)
Cruise Control Switch: Service and Repair
Cruise Control Combination Switch Test/Replacement
Cruise Control Combination Switch Test/Replacement
There are SRS components located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations, and the
precautions and procedures See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air Bag(s) Arming and Disarming/Service
and Repair, in the SRS before doing repairs or service.
1. Remove the steering wheel See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Removal and Replacement/Steering Wheel
Removal and disassemble the steering wheel See: Steering and Suspension/Steering/Steering Wheel/Service and Repair/Overhaul.
2. Disconnect the cable real subharness connector (A) and the steering wheel center trim (B), then remove the steering wheel trim/cruise control
combination switch (C).
3. Check for continuity between the terminals in each switch position according to the table.
-
If there is continuity, and it matches the table, but the cruise control combination switch failure occurred on the cruise control input test, check
and repair the wire harness on the switch circuit.
-
If there is no continuity in one or both positions, replace the steering wheel trim/cruise control combination switch.
