ZDX V6-3.7L (2010)
13. After removing a piston/connecting rod assembly, reinstall the rod cap on the rod.
14. To avoid confusion during reassembly, mark each piston/connecting rod assembly with its cylinder number.
15. Loosen the bearing cap bolts and the bearing cap side bolts in sequence 1/3 turn at a time; repeat the sequence until all bolts are loosened.
16. Remove the bearing cap bolts (A) and the bearing cap side bolts (B), then remove the main bearing caps (C).
17. Lift the crankshaft (A) out of the engine block, being careful not to damage the journals and the crankshaft position (CKP) pulse plate (B).
