ZDX V6-3.7L (2010)
24. Remove all of the old liquid gasket from the engine block end cover mating surfaces, the bolts, and the bolt holes.
25. Clean and dry the engine block end cover mating surfaces and the crankshaft oil seal housing.
26. Apply a light coat of new engine oil to the lip of the crankshaft oil seal.
27. Using the driver handle, 15 x135 L and the oil seal driver attachment, 106 mm, drive in the new crankshaft oil seal (A) until the oil seal driver
attachment bottoms on the engine block end cover.
28. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the engine block end cover
and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
