ZDX V6-3.7L (2010)
NOTE: The front injector base gasket is different from the rear one. Do not mix injector base gasket types.
2. Connect the knock sensor connector (A) and install the harness holder mounting bolt (B).
3. Install the injectors See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair.
4. Install the intake manifold See: Intake Manifold Removal/Installation.
5. Install the P/S pump and the P/S hose bracket See: Cylinder Head Assembly/Service and Repair/Removal and Replacement/Cylinder Head
Installation.
6. Install the drive belt See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair.
7. Inspect for fuel leaks. Turn the ignition switch to ON (II),or press the engine start/stop button to select the ON mode (do not operate the starter) so
the fuel pump runs for about 2 seconds and pressurizes the fuel line. Repeat this operation three times, then check for fuel leakage at any point in
the fuel line.