ZDX V6-3.7L (2010)
15. Set the camshaft pulleys to top dead center (TDC) before bolting them onto the engine block See: Cylinder Head Assembly/Service and
Repair/Removal and Replacement/Cylinder Head Installation.
Rear
1. Loosen the locknuts and the adjusting screws.
2. Clean and dry the camshaft oil seal housing.
3. Apply a light coat of new engine oil to the lip of the camshaft oil seal.
4. Gently tap the new camshaft oil seal (A) into the cylinder head.
1. Tap the camshaft oil seal in squarely.
2. Install the oil seal about 0.5-1.5 mm (0.020-0.059 in) below the surface of the cylinder head.
5. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
journals and the cam lobes.
6. Clean the excess grease off the camshaft, and check that the oil seal lip is not distorted.
7. Install the dowel pin (E).