ZDX V6-3.7L (2010)
Blower Motor: Service and Repair
Blower Unit Removal/Installation
Blower Unit Removal/Installation
1. Remove these items:
-
Passenger's dashboard undercover See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Passenger's Dashboard Undercover Removal/Installation
-
Passenger's dashboard trim See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Passenger's
Dashboard Trim Removal/Installation
-
Glove box See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair/Glove Box Removal/Installation
-
Passenger's kick panel See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair
2. Remove the harness clips (A), the bolts, and the glove box frame (B).
3. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown. Retain the plastic cross brace to be reinstalled
later.
4. Release the wire from its harness clip (A), then remove the self-tapping screws, and the passenger's heater duct (B).