ZDX V6-3.7L (2010)
7. Remove the bolts, then remove the A/C condenser upper mount brackets (A). Remove the A/C condenser (B) by lifting it up. Be careful not to
damage the radiator or the A/C condenser fins when removing the A/C condenser.
8. Install the A/C condenser in the reverse order of removal, and note these items:
-
If you're installing a new A/C condenser, add refrigerant oil (DENSO ND-OIL 8) See: Refrigerant Oil/Service and Repair.
-
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the correct
O-rings for HFC-134a (R-134a) to avoid leakage.
-
Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
-
Do not spill the refrigerant oil on the vehicle; it may damage the paint; if the refrigerant oil contacts the paint, wash it off immediately.
-
Be careful not to damage the radiator or the A/C condenser fins when installing the A/C condenser.
-
Charge the system See: Service and Repair/A/C System Charging.
9. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
