ZDX V6-3.7L (2010)
Air Bag Deactivation Indicator: Service and Repair
Passenger's Airbag Cutoff Indicator Replacement
1. With navigation system: Remove the audio-navigation and HVAC switch panel See: Accessories and Optional Equipment/Radio, Stereo, and
Compact Disc/Service and Repair/Audio-Navigation and HVAC Switch Panel Removal/Installation.
2. Without navigation system: Remove the audio and HVAC switch panel See: Accessories and Optional Equipment/Radio, Stereo, and Compact
Disc/Service and Repair/Audio and HVAC Switch Panel Removal/Installation.
3. Disconnect the hazard warning switch/passenger's airbag cutoff indicator 6P connector (A) on the dashboard wire harness.
4. Push out the hazard warning switch/passenger's airbag cutoff indicator (B) from behind the switch panel (C).
5. Reinstall the parts in the reverse order of removal.
6. After installing the hazard warning switch/passenger's airbag cutoff indicator, confirm proper system operation:
-
Clear any DTCs with the HDS See: Restraint Systems/Air Bag Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble
Codes.
-
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and check that the SRS indicator comes on for
about 6 seconds and then goes off.