ZDX V6-3.7L (2010)
15. After disconnecting the quick-connect fitting, check it for dirt or damage.
16. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
Without the HDS
1. Remove PGM-FI main relay 2 (A) from the driver's under-dash fuse/relay box.
2. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore them.
3. Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.
4. Remove the fuel fill cap to relieve the pressure in the fuel tank.
5. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
6. Remove the quick-connect fitting cover (A).
