ZDX V6-3.7L (2010)
6. Disconnect the lower arm ball joint from the knuckle using the ball joint thread protector and the ball joint remover See: Steering and
Suspension/Suspension/Ball Joint/Service and Repair/Ball Joint Removal.
NOTE:
-
Be careful not to damage the ball joint boot when installing the remover.
-
Do not force or hammer on the lower arm, or pry between the lower arm and the knuckle. You could damage the ball joint.
7. Remove the damper pinch bolts (A) and flange nuts (B) from the damper, then remove the knuckle (C).
NOTE: During installation, install new damper pinch bolts and new flange nuts.
8. Install the knuckle in the reverse order of removal, and note these items:
-
Be careful not to damage the ball joint boot when connecting the knuckle.
-
Before connecting the ball joint to the knuckle, degrease the threaded section and the tapered portion of the ball joint pin, the ball joint
connecting hole, the threaded section and the mating surfaces of the castle nut.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
9. Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
