ZDX V6-3.7L (2010)
Fuel Level Sensor: Service and Repair
Fuel Tank Unit Removal/Installation
Fuel Tank Unit Removal and Installation
Special Tools Required
-
Fuel Sender Wrench 07AAA-S0XA100
Removal
1. Relieve the fuel pressure See: Fuel Delivery and Air Induction/Fuel Filter/Fuel Pressure Release/Service and Repair.
2. Remove the rear seat cushion See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation.
3. Remove the access panel (A) from the floor.
4. Disconnect the fuel tank unit 4P connector (B).
5. Disconnect the quick-connect fitting (C) from the fuel tank unit.
6. Using the fuel sender wrench, loosen the locknut (A).