ZDX V6-3.7L (2010)
6. Connect the fuel tank unit 4P connector.
7. Reconnect the quick-connect fitting to the fuel tank unit.
8. Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
9. Turn the ignition switch to ON (II)/press the engine start/stop button to select the ON mode (but do not operate the starter motor). The fuel pump
will run for about 2 seconds, and fuel pressure will rise. Repeat this two or three times, then make sure there are no fuel leaks.
10. Install the access panel on the floor.
11. Install the rear seat cushion See: Body and Frame/Seats/Service and Repair/Rear Seat Removal/Installation.
