ZDX V6-3.7L (2010)
Information Bus: Component Tests and General Diagnostics
Troubleshooting - B-CAN System Diagnosis Test Mode D
Multiplex Integrated Control System Troubleshooting - B-CAN System Diagnosis Test Mode D
Do this diagnosis if a component that is controlled by the B-CAN system does not run or come on.
NOTE:
-
If the component does not turn off or stop, go to B-CAN System Diagnosis Test Mode C See: Troubleshooting - B-CAN System Diagnosis Test
Mode C.
-
See the B-CAN system unit input/output index for a list of input and output devices and the control units that monitor the input and control the
output devices See: Description and Operation.
1. Check the fuse of the malfunctioning output device.
Is the fuse OK?
YES -
Go to step 2.
NO -
Replace the fuse and recheck.
2. Check for DTCs by selecting the system MODE MENU from the HDS.
Are any DTCs indicated ?
YES -
Go to B-CAN System Diagnosis Test Mode A See: Troubleshooting - B-CAN System Diagnosis Test Mode A.
NO -
Go to step 3.
3. Turn ON the switch that controls the malfunctioning component.
4. Select the applicable system from the system MODE MENU, then select DATA LIST, and check the input of the switch that controls the related
component.
Is there an output signal?
YES -
Go to step 5.
NO -
Go to step 9.
5. Check the relay (if applicable) and ground, then check for an open or a short in the circuit for the malfunctioning component.
Are the relay and the circuit OK?
YES -
Go to step 6.
NO -
Replace the relay or repair the wire circuit.
