ZDX V6-3.7L (2010)
11. Install the injector clips (D).
12. Coat the new injector O-rings (green) (E) with clean engine oil.
13. Install the fuel rails and the injectors in the injector base (F).
14. Reinstall the fuel rail mounting bolts, and connect the injector connectors.
15. Reinstall the fuel joint hose mounting bolt.
16. Connect the quick-connect fitting See: Fuel Line Coupler/Service and Repair/Fuel Line/Quick-Connect Fitting Installation.
17. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, but do not operate the starter. After the fuel pump
runs for about 2 seconds, the fuel rail will be pressurized. Repeat this two or three times, then make sure there are no fuel leaks.
18. Reinstall the intake manifold with a new gasket See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair/Intake Manifold
Removal/Installation.