ZDX V6-3.7L (2010)
Throttle Body: Procedures
Throttle Body Cleaning
CAUTION
Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II)/press the engine start/stop button, or
while the ignition switch is in ON (II)/vehicle in ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.
1. Check for damage to the air cleaner. If the air cleaner is damaged, replace it See: Air Cleaner Housing/Air Filter Element/Service and Repair.
2. Remove the throttle body See: Removal and Replacement.
3. Clean off the carbon from the throttle valve and inside the throttle body with a paper towel soaked in throttle plate cleaner.
NOTE:
-
Remove the throttle body to clean it.
-
Be careful not to pinch your fingers.
-
To avoid removing the molybdenum coating, do not clean the bearing area of the throttle shaft (A).
-
Do not spray throttle plate cleaner directly on the throttle body.
-
Use Acura genuine throttle plate cleaner.
4. Install the throttle body See: Removal and Replacement.
5. Reset the PCM with the HDS See: Computers and Control Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview.
6. Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode, and wait 2 seconds.
7. Do the PCM idle learn procedure See: Computers and Control Systems/Testing and Inspection/Programming and Relearning/PCM Idle Learn
Procedure.