ZDX V6-3.7L (2010)
Fluid Pressure Sensor/Switch: Service and Repair
Transmission Fluid Pressure Switch A (2nd Clutch) Replacement
Transmission Fluid Pressure Switch A (2nd Clutch) Replacement
1. Remove the air cleaner See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair.
2. Remove the intake air duct See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Removal.
3. Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove transmission fluid pressure switch A (2nd clutch) (A) and
the sealing washer (B).
4. Install a new transmission fluid pressure switch A (2nd clutch) and a new sealing washer, and tighten the switch.
5. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.
6. Install the intake air duct See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and Repair/Removal and
Replacement/Automatic Transmission Installation.
7. Install the air cleaner See: Fuel Delivery and Air Induction/Air Cleaner Housing/Service and Repair.